My SBR form 1 project

[MAS GunWorks]

Both form 1's took about 30 days from the time I mailed them until I had the approved forms in my hands. I put both form 1's in my trust.

Just started to put together my form 1 sbr. It is almost done but will soon have another transformation. I am adding a rail system and suppressor. That is once I get the suppressor built (another form 1 project). The suppressor will be all stainless and should end up around 8-9 inches long. Hopefully I can find a rail system I like that will fit over the suppressor and still look good.

Below are some of the parts I am using but some of them will change when I make the next upgrade.

Essential Arms lower
DPMS lower parts kit
DPMS 7.5 inch barrel and front sight
DPMS bolt
DPMS charging handle
Rock river collapsible stock
Rock river detachable carry handle

When I add the suppressor I will install a low profile gas block, rail system and suppressor. Should make for a pretty cool setup. Now to see if it works.

I haven't decided if I am going to color in the engraving or leave it like it is.

http://i55.photobucket.com/albums/g143/Tazdev67/AR15/IMG_0475-1.jpg
http://i55.photobucket.com/albums/g143/Tazdev67/AR15/IMG_0477-1.jpg

[RobC]

Wow, that flamethrower is going to be loud. You need to shoot that at night sometime.


Sweet setup!

[MAS GunWorks]

It isn't going to stay in this configuration very long. I am working on a suppressor for it right now. Believe it or not it isn't a lot louder then a regular 16" barrel. I will have to shoot it one night to see what that looks like.

I plan on build several uppers for it but haven't decided what calibers yet.

[RobC]

A 9mm is among the first uppers I plan for my SBR build. I'm going to put a 4 or 5 inch three lug barrel under a KAC freefloat rail and put my Trident on it.

If I can locate a KAC M4QD suppressor anytime soon, I will build a MK18 upper first.

[DrBaker]

"That's hot", said Paris.

[761mph]

who did your reciver engraving ?