Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
742
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="jackinok09" data-source="post: 3859753" data-attributes="member: 51322"><p>I've not had trouble with mine so far . but as others have said they need to be clean. Clean guide rod and recoil spring and oil it good. Gas tube of course, and if it's been sitting a long time make sure it's not rusted around gas tube. Pull two pins and whole trigger assy will pull out. Make sure safety stays on or hold hammer and ease it down . Check and really clean good rails where bolt slides. I use gun grease and lightly grease these. And wherever looks like wear point. Some say don't use grease as low temperatures can mess it up but there's several good brands rated to way below zero now days. Also I heard that aftermarket mags can cause problems, I bought an original remington 2 round mag off internet recently just to have backup and it works great. Good luck!</p></blockquote><p></p>
[QUOTE="jackinok09, post: 3859753, member: 51322"] I've not had trouble with mine so far . but as others have said they need to be clean. Clean guide rod and recoil spring and oil it good. Gas tube of course, and if it's been sitting a long time make sure it's not rusted around gas tube. Pull two pins and whole trigger assy will pull out. Make sure safety stays on or hold hammer and ease it down . Check and really clean good rails where bolt slides. I use gun grease and lightly grease these. And wherever looks like wear point. Some say don't use grease as low temperatures can mess it up but there's several good brands rated to way below zero now days. Also I heard that aftermarket mags can cause problems, I bought an original remington 2 round mag off internet recently just to have backup and it works great. Good luck! [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
742
Search titles only
By:
Top
Bottom