Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
Gunsmith in OKC/Edmond for AR Work
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="pQRSt" data-source="post: 2060399" data-attributes="member: 26773"><p>(Watching this game is not safe with guns in the house...)</p><p></p><p>As for what's wrong with it....my Larue 7.62 OBR won't come apart. My front and read takedown pins come out fine, but it won't separate at the rear pin location. I think the buffer detent pin has failed/broken which is keeping them from coming apart now...</p><p>So you'd think I could just remove the stock and come at it from behind...but the screw that holds the PRS stock in place was set with red loctite, so that screw is going no where. I feel that I'm going to strip the screw if I try an harder...so I figured I'd just stop here and get someone to help that has more skill than me.</p></blockquote><p></p>
[QUOTE="pQRSt, post: 2060399, member: 26773"] (Watching this game is not safe with guns in the house...) As for what's wrong with it....my Larue 7.62 OBR won't come apart. My front and read takedown pins come out fine, but it won't separate at the rear pin location. I think the buffer detent pin has failed/broken which is keeping them from coming apart now... So you'd think I could just remove the stock and come at it from behind...but the screw that holds the PRS stock in place was set with red loctite, so that screw is going no where. I feel that I'm going to strip the screw if I try an harder...so I figured I'd just stop here and get someone to help that has more skill than me. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
Gunsmith in OKC/Edmond for AR Work
Search titles only
By:
Top
Bottom