Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Hobbies & Interests
Preppers' Corner
Hand pump water well
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="cowadle" data-source="post: 2274532" data-attributes="member: 7203"><p>need a pic.. if it is what i think it is the pump is down in the well. it is called a well cylinder and has leathers in it on the plunger and another leather foot valve. you will need to lift the pump jack from the top of the well and with two pipe wrenches unscrew the 2 inch pipe just under the jack. make sure you have a chain around the tubing so as to not drop it in the well lift the pump jack up and separate the jet rod at the rod box. repeat at every joint until the cylinder is out of the well. then you can unscrew the ends from the cylinder and replace the leathers. they last forever! measure the ID of the cyl and get some leathers. most are 3 inch.</p></blockquote><p></p>
[QUOTE="cowadle, post: 2274532, member: 7203"] need a pic.. if it is what i think it is the pump is down in the well. it is called a well cylinder and has leathers in it on the plunger and another leather foot valve. you will need to lift the pump jack from the top of the well and with two pipe wrenches unscrew the 2 inch pipe just under the jack. make sure you have a chain around the tubing so as to not drop it in the well lift the pump jack up and separate the jet rod at the rod box. repeat at every joint until the cylinder is out of the well. then you can unscrew the ends from the cylinder and replace the leathers. they last forever! measure the ID of the cyl and get some leathers. most are 3 inch. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
Hobbies & Interests
Preppers' Corner
Hand pump water well
Search titles only
By:
Top
Bottom