Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
I need help with crown moulding gaps
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Snattlerake" data-source="post: 3714938" data-attributes="member: 44288"><p>That was the second attempt.</p><p></p><p>45</p><p></p><p>I used this. I didn't cope them because I flunked coping saw. I made a scarpwood jig to mark the ceiling and wall where the crown would fit and the furring strips were "relieved" of stress by cutting relief cuts halfway through all along the strip on both sides. After acclimating the strips, I could only use about half of the bundle because of the crooked bends. That's when I relieved the strips with the cuts. I checked the corners for square and the spring angle was perfect.</p><p>[ATTACH=full]248655[/ATTACH]</p></blockquote><p></p>
[QUOTE="Snattlerake, post: 3714938, member: 44288"] That was the second attempt. 45 I used this. I didn't cope them because I flunked coping saw. I made a scarpwood jig to mark the ceiling and wall where the crown would fit and the furring strips were "relieved" of stress by cutting relief cuts halfway through all along the strip on both sides. After acclimating the strips, I could only use about half of the bundle because of the crooked bends. That's when I relieved the strips with the cuts. I checked the corners for square and the spring angle was perfect. [ATTACH type="full"]248655[/ATTACH] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
I need help with crown moulding gaps
Search titles only
By:
Top
Bottom