Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
I'm doing something wrong but don't know what!
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="gmar" data-source="post: 1378687" data-attributes="member: 9154"><p>I'm still new to reloading and have only loaded approximately 250 rounds of 6.5 Grendel. The first 200 were virgin brass and didn't have any problems. The last 50 (brass shot 1x) is a different story. I loaded them and one of the got stuck in the chamber. I was told to get a case gauge to make sure the brass was properly resized. I pulled apart the 50 rounds and they were not resized properly. Ran them through the dies once again and tested them with the gauge and they easily fit into it and were the proper length. Bthe rim of the brass is even with the lower edge of the gauge.</p><p></p><p>Anyway, I went to shoot on Saturday and they are getting stuck in the chamber again. If I load from a magazine, the chamber doesn't fully close and I have to slam the stock on the ground and pull the charging handle at the same time. </p><p></p><p>However, if I load one round into the chamber and hit the bolt release it fully engages and shoots fine...95% of the time. The other 5% of the time, it does the same thing.</p><p></p><p>Any ideas on what I'm doing wrong?</p></blockquote><p></p>
[QUOTE="gmar, post: 1378687, member: 9154"] I'm still new to reloading and have only loaded approximately 250 rounds of 6.5 Grendel. The first 200 were virgin brass and didn't have any problems. The last 50 (brass shot 1x) is a different story. I loaded them and one of the got stuck in the chamber. I was told to get a case gauge to make sure the brass was properly resized. I pulled apart the 50 rounds and they were not resized properly. Ran them through the dies once again and tested them with the gauge and they easily fit into it and were the proper length. Bthe rim of the brass is even with the lower edge of the gauge. Anyway, I went to shoot on Saturday and they are getting stuck in the chamber again. If I load from a magazine, the chamber doesn't fully close and I have to slam the stock on the ground and pull the charging handle at the same time. However, if I load one round into the chamber and hit the bolt release it fully engages and shoots fine...95% of the time. The other 5% of the time, it does the same thing. Any ideas on what I'm doing wrong? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
I'm doing something wrong but don't know what!
Search titles only
By:
Top
Bottom