Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Magnetospeed
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Mad Professor" data-source="post: 2877463" data-attributes="member: 5316"><p>I have the V3 and love it. It does have some minor limitations/issues but the advantages far make up for those. </p><p>If you try to clock non-jacketed, slow bullets you may run into issues. Plated bullets helps, jacketed is better. No problems. I was in the mid 600fps area and tech support confirmed the limitations. I've mainly used it un railed pistols, and various AR configurations. I've also strapped it to a revolver and a couple of suppressors. I do have to adjust the sensitivity to suit the configuration. For instance 300blk 200g sub have to be set more sensitive than 110g supers. The error are obvious though. Either no reading or it doubles the speed. </p><p></p><p>I wish they would make some changes in the way it interfaces with an iPhone.</p><p>You are basically limited to viewing the most current string. You have to disconnect from the sensor to do that. Still nice, but I have to connect, sync, and email after each string of fire to compare results in the field. </p><p></p><p>I need to try taking my laptop and pulling the memory card. </p><p></p><p>In the plus side. I can setup in 5 minutes on a hot range and not have to disturb anyone. Same with tear down. </p><p></p><p></p><p>I'd buy it again if doing it over!</p></blockquote><p></p>
[QUOTE="Mad Professor, post: 2877463, member: 5316"] I have the V3 and love it. It does have some minor limitations/issues but the advantages far make up for those. If you try to clock non-jacketed, slow bullets you may run into issues. Plated bullets helps, jacketed is better. No problems. I was in the mid 600fps area and tech support confirmed the limitations. I've mainly used it un railed pistols, and various AR configurations. I've also strapped it to a revolver and a couple of suppressors. I do have to adjust the sensitivity to suit the configuration. For instance 300blk 200g sub have to be set more sensitive than 110g supers. The error are obvious though. Either no reading or it doubles the speed. I wish they would make some changes in the way it interfaces with an iPhone. You are basically limited to viewing the most current string. You have to disconnect from the sensor to do that. Still nice, but I have to connect, sync, and email after each string of fire to compare results in the field. I need to try taking my laptop and pulling the memory card. In the plus side. I can setup in 5 minutes on a hot range and not have to disturb anyone. Same with tear down. I'd buy it again if doing it over! [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Magnetospeed
Search titles only
By:
Top
Bottom