Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Hobbies & Interests
Hunting & Fishing
Pluging your .22(3) cal mags for Deer Gun
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="AMT7" data-source="post: 2641291" data-attributes="member: 32064"><p>Problem solved.</p><p>7 round Gen 3 Pmag from 10 rounder recipe:</p><p> 1/8 drill bit, cordless drill, 1/8 dia aluminum rivet correct length & 5 minutes, bam! done cost $0 with existing supplies.</p><p><a href="https://www.dropbox.com/s/rdmihhqxzk25x39/2014-10-21%2003.40.26.jpg?dl=0" target="_blank">https://www.dropbox.com/s/rdmihhqxzk25x39/2014-10-21 03.40.26.jpg?dl=0</a></p><p></p><p>Below is interior pic of rivet tail correct protrusion on rear of mag which is at top of pic.</p><p><a href="https://www.dropbox.com/s/fvmk0hht8e1duvn/2014-10-21%2003.41.59.jpg?dl=0" target="_blank">https://www.dropbox.com/s/fvmk0hht8e1duvn/2014-10-21 03.41.59.jpg?dl=0</a></p><p>Note: you will either need to use flush rivet and carefully use larger drill or countersink hole a bit or file about 50% of the protrusion head off to clear mag well. Do not use protrusion head cherry max type rivets with lock rings in head as filing it down will cause ring & stem to fall out.</p></blockquote><p></p>
[QUOTE="AMT7, post: 2641291, member: 32064"] Problem solved. 7 round Gen 3 Pmag from 10 rounder recipe: 1/8 drill bit, cordless drill, 1/8 dia aluminum rivet correct length & 5 minutes, bam! done cost $0 with existing supplies. [url]https://www.dropbox.com/s/rdmihhqxzk25x39/2014-10-21%2003.40.26.jpg?dl=0[/url] Below is interior pic of rivet tail correct protrusion on rear of mag which is at top of pic. [url]https://www.dropbox.com/s/fvmk0hht8e1duvn/2014-10-21%2003.41.59.jpg?dl=0[/url] Note: you will either need to use flush rivet and carefully use larger drill or countersink hole a bit or file about 50% of the protrusion head off to clear mag well. Do not use protrusion head cherry max type rivets with lock rings in head as filing it down will cause ring & stem to fall out. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
Hobbies & Interests
Hunting & Fishing
Pluging your .22(3) cal mags for Deer Gun
Search titles only
By:
Top
Bottom