Building my first SBR

[MrShooter]

The trigger is the DPMS TiNi coating. The screw on B.A.D. lever is a brass machine screw I used because the tards at magpul who packaged it left out the black s few it came with. And the badger ordinance latch/vltor CH is just scraped paint. I'm looking to change out my taledown pins to KNS.

I doubt its visible but I also installed those kns mod 2 Gen 2 pins.

 

[Ignored Member]

Whew... good. I thought you were trying to make a Ronald McDonald gun for a second there.

 

[MrShooter]

Hahahahahahahababahahahahahahahahahaha.

But on a serious note... I'm having function issues. At first it was light primer strikes, now my mags wont hold in place unless the bolt is back AND light primer strikes. (since I installed bad lever)

I'm open to ideas..

 

[MrShooter]

By the way, 5.56 runs GREAT. 9MM IS THE ISSUE.

 

[Ignored Member]

As far as the mags not holding in place. Try to adjust the magblock up or down slightly, it may be riding the mag catch a little bit. For the light primer strikes you might check the firing pin to make sure it's protruding out of the bolt enough.
I can't think of why the B.A.D. lever would mess up the function at all since it attaches to nothing but the paddle of the bolt release.

9mm AR's always seem to have a few kinks you have to play with a lil bit.

 

[MrShooter]

I got it figured out.

The light primer strikes are from a short protruding pin, CMMG is stepping up and sending me a whole new BCG!
The mag problem is due to an out of spec dpms magazine release.
I'm getting a brand new CMMG 9mm enhanced BCG for free. Big thumbs up to them.

 

[Ignored Member]

nice.

 

[CAR-AR-M16]

I got it figured out.

The light primer strikes are from a short protruding pin, CMMG is stepping up and sending me a whole new BCG!
The mag problem is due to an out of spec dpms magazine release.
I'm getting a brand new CMMG 9mm enhanced BCG for free. Big thumbs up to them.

Glad to hear you got it figured out and that the manufacturer is standing behind their product.

 

[djcorrell]

This may be out of line, but can you have a multi cal sbr lower? Or do you just get one on the books and do what you want?

 

[MrShooter]

i put 9mm 5.56mm & .22lr on my form 1