I could see this put to good use on our southern border.
There are possibilities I'm going to explore. It only uses blanks, so there is not much possibility of any over pressure problems.
Can anyone say canister/beehive rounds?
There are possibilities I'm going to explore. It only uses blanks, so there is not much possibility of any over pressure problems.
Can anyone say canister/beehive rounds?
Uhh, yeah. When I was a detachment commander I got to see the aftermath of a 105 battery shooting beehives at 200 silhouettes.
All I can say is WOW!
You can buy the beehive projectiles online. I’ve seen some folks load them in shot shells in videos, although I never have.
It's not pinpoint accurate at close range because the golf ball needs to start spinning for the dimples to stabilize it. When you shoot it, the ball makes a little deviation from the point of aim but then goes straight. When shooting it this afternoon, I had a new scope that is not sighted in and both shots aimed at the middle of the board hit to the right by about 7" pretty consistent, so It could have been the scope or the ball trying to establish stability.
I was 30 yards away from the board hiding behind the tractor because I didn't know what was going to happen and didn't want to catch a golf ball in the nards if it bounced off.
Sounds like a slight fade you have there.
I got this...
.
No, wait.... I already had that.
I got this....
To put in it....
A Bill Davis PPC revolver, built on a 10-5.
.
No, wait.... I already had that.
I got this....
To put in it....
A Bill Davis PPC revolver, built on a 10-5.
Picked up a boxed 2.5" 66-2 from D V US in trade and ordered a set of Ahrends Goncalo Alves retro banana grips (retro combat without finger grooves) and a TT Gunleather Elite Snap OWB for it. Grips should be here tomorrow...holster wait will be approx 3 weeks.
I'll likely post a photo of the 66 tomorrow after the grips have arrived.
I'll likely post a photo of the 66 tomorrow after the grips have arrived.
I’ve been on a custom pistol kick lately. Buying, selling, and trading for different ones. I got this guy in trade on Friday. I think it will be a fun little shooter. It’s a CZ P10c with some custom work on the slide, frame, and trigger + an RMR.
Got my new holster for my Beretta APX today. It's from Beretta, made in Italy. Seems to be of equal quality to the Craft holsters I normally buy (not a lot of choices out there for an APX). It is a little tight, though. Have already commenced with the 'baggie maneuver'. Overall, very happy!
