45 acp taper

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Cowcatcher

Unarmed boating accident survivor
Supporting Member
Special Hen Supporter
Joined
Dec 22, 2017
Messages
6,171
Reaction score
13,853
Location
Inola
I believe your stickiness issue is in your seat/taper crimp Die. I've belled cases way too far with Lee expander but you'd never know or feel it once it comes out of that Die and goes through the lee seat or especially by the time it gets to the Lee FCD.
 
Last edited:

Shadowrider

Sharpshooter
Supporting Member
Special Hen Supporter
Joined
Jan 28, 2008
Messages
21,532
Reaction score
9,348
Location
Tornado Alley
I have several sets of the Hornady dies in pistol calibers. The sleeve setup in the seating die is great for seating bullets. Not so much for crimping. They don't use a taper crimp. It's basically an abrupt angle. It's not a roll crimp either but it's closer to a roll than taper. They don't crimp worth a damn IMO. Also if you flare too much it'll be sticky going into the sleeve in the seating die. It's definitely best to buy a seperate taper crimp die and do that operation last as a stand alone die. I like Redding myself.

Like you I got them for the free bullets. They aren't bad dies at all except for the crimping.
 

tkdgeek

Marksman
Special Hen
Joined
Oct 18, 2017
Messages
38
Reaction score
17
Location
Yukon, ok
Took me a couple days to get one shipped in from the tall people who protect that river...
Didn't get out to our farm to check on things until Saturday and took a box with me I'd already made trying out a few loads for the new 230gr I'm switching to. Loading fresh, using Hornady only for seating and then grabbing the new Lee Carbide Factory Crimp on them was really nice and well worth the few dollars. Did a nice job on the 185g XTP's as well.
Thank you much.
 

Good Cheer

Marksman
Special Hen
Joined
Sep 4, 2010
Messages
55
Reaction score
8
Location
moved to Indiana
Being a cast shooter, belling and then straightening out is what I do. RCBS dies working without problem. The mold is adjusted to make the front band engrave, centering on the rifling. Straightening out takes the case mouth right to the bullet. Bullets don't move in the cases when being driven into the lands. That's what works for my cardboard killers (not saying for anybody else and absolutely not the way you make jacketed loads).
 

Latest posts

Top Bottom