Search Results

PM sent

Found ya. Enjoy the banter

Nice Job! I have one of those rifles. I guess I better check it before a potential failure occurs.

Out of stock

The high temp was just after midnight sorry to kill the glitch theory

What he said. I love my Xd’s in full size and subcompact. I’ve done the same for my XD 9 by adding a slide from a 40 gave me a new gun without the high cost. The 40 is a hard hitting round I’ll give it that.

They were a staple for me as kid growing up. I haven't had one in a hot minute.

My brother-in-law had an issue with TSA they told him he had to have a lock on each side of the case because it could be opened at the corner. Might be safe and use two locks

Pm sent

I saw this yesterday more overreach :angry3:

Yessir this is what it looks like

Thanks that’s vey nice of you.

I’ve taken off the end plate and can’t find any identification, it’s a 5/8 d shaft on the fan side the drive side has a gear that I can’t figure out how to remove. Here are some pictures of the strange end plate that I’ve removed the gear reduction from so you can see the drive gear And the...

From the manufacture

Yes sir, 15 amp.

Thanks Mac, I reached out to them.

Just called a place that works on electric motors and diagnostic fee is $140/hr. This free grinder will cost me more than a new one if I go down that road. He said sounds like the run winding is not energizing. I could replace the motor if I knew the rpm and form factor but no markings or...

yes, same results after the cord as before

I only see a start capacitor which is rated at 110 to 147 micro faraids (? spelled wrong)

About 5 to 6 seconds then trips the on board breaker