Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
223 reloading question
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="victor3ranger" data-source="post: 1776936" data-attributes="member: 462"><p>To answer some of the questions.</p><p>I have tried three different sets of dies, all with the same results. 2 RCBS and 1 LEE.</p><p>I have cleaned and cleaned the chamber, inspected with a bore light, everything is spotless, so that isn't the problem.</p><p>I have also taken two other AR's with NATO chambers and the brass falls into and out of the other two, so I am leaning towards this one AR having a tighter chamber.</p><p>I went ahead and ordered a SB die, so when it comes in I will take some of the tight fitting brass and run it thru the SB die and check it again.</p><p>It feels like the last 1/8" or 1/16" or so of the brass above the base isn't getting squeezed down enough with the FL die.</p><p>Sure hope it solves the problem.</p><p>If it dosen't I will see if I can do what you guys say about sending in some of the brass and one set of my FL dies back to RCBS.</p></blockquote><p></p>
[QUOTE="victor3ranger, post: 1776936, member: 462"] To answer some of the questions. I have tried three different sets of dies, all with the same results. 2 RCBS and 1 LEE. I have cleaned and cleaned the chamber, inspected with a bore light, everything is spotless, so that isn't the problem. I have also taken two other AR's with NATO chambers and the brass falls into and out of the other two, so I am leaning towards this one AR having a tighter chamber. I went ahead and ordered a SB die, so when it comes in I will take some of the tight fitting brass and run it thru the SB die and check it again. It feels like the last 1/8" or 1/16" or so of the brass above the base isn't getting squeezed down enough with the FL die. Sure hope it solves the problem. If it dosen't I will see if I can do what you guys say about sending in some of the brass and one set of my FL dies back to RCBS. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
223 reloading question
Search titles only
By:
Top
Bottom