Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
308 necks too loose? Need help.
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Ksmirk" data-source="post: 1024827" data-attributes="member: 880"><p>I've run into this problem before, pretty simple fix actually. I was preping a mess of brass for a p-dog hunt and was doing it in batches of 50, got to dumping powder and seating bullets when out of the blue the bullets fell onto the podwer charge ??? I measured the necks and ya know what granted I had the decapping rod long enough to knock out the primer the die was not far enough down to size the necks! I just removed the decapping rod and ran them back into the die after screwing it down a bit so that it would size the neck to the correct dia. I bet the look on my face after that was priceless the look of confusion. Oh well we all do things loading that we swear we were paying attention but a few can sneak by. Later,</p><p></p><p>Kirk</p></blockquote><p></p>
[QUOTE="Ksmirk, post: 1024827, member: 880"] I've run into this problem before, pretty simple fix actually. I was preping a mess of brass for a p-dog hunt and was doing it in batches of 50, got to dumping powder and seating bullets when out of the blue the bullets fell onto the podwer charge ??? I measured the necks and ya know what granted I had the decapping rod long enough to knock out the primer the die was not far enough down to size the necks! I just removed the decapping rod and ran them back into the die after screwing it down a bit so that it would size the neck to the correct dia. I bet the look on my face after that was priceless the look of confusion. Oh well we all do things loading that we swear we were paying attention but a few can sneak by. Later, Kirk [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
308 necks too loose? Need help.
Search titles only
By:
Top
Bottom