Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
If you have bought, sold or gained information from our Classifieds, please donate to OKShooters Association and give back.
You can
become a Supporting Member
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Classifieds
Want To Buy Ads
7mm Mauser (7x57) brass - Found the dies!
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="swampratt" data-source="post: 3832815" data-attributes="member: 15054"><p>All the bullets I have pulled were with a simple inertia puller.</p><p>No marks on the bullet at all.</p><p>No way to pull a soft lead bullet and reuse it with a collet puller.</p><p></p><p>I made my inertia puller just a block or cedar with a hole drilled into it and foam ear plug in the bottom.</p><p>Hole big enough to slid the brass case into and use the shell holder to hold the case from falling into the hole.</p><p>Hold shell holder with case inserted into the block and pound the block on an anvil.</p><p>I use a steel weight off a weight bench I place in my lap.</p><p></p><p>I used large zip ties to hold the shell holder because holding with a finger hurts after a few wacks.</p><p></p><p>There are better ways to build an inertia puller but this one has worked for me since I began reloading.</p></blockquote><p></p>
[QUOTE="swampratt, post: 3832815, member: 15054"] All the bullets I have pulled were with a simple inertia puller. No marks on the bullet at all. No way to pull a soft lead bullet and reuse it with a collet puller. I made my inertia puller just a block or cedar with a hole drilled into it and foam ear plug in the bottom. Hole big enough to slid the brass case into and use the shell holder to hold the case from falling into the hole. Hold shell holder with case inserted into the block and pound the block on an anvil. I use a steel weight off a weight bench I place in my lap. I used large zip ties to hold the shell holder because holding with a finger hurts after a few wacks. There are better ways to build an inertia puller but this one has worked for me since I began reloading. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
Classifieds
Want To Buy Ads
7mm Mauser (7x57) brass - Found the dies!
Search titles only
By:
Top
Bottom