Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
9mm PCC
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="dennishoddy" data-source="post: 3246797" data-attributes="member: 5412"><p>Well, went to the range today and loaded up the mag. Started with two shots in rapid fire mode, then after about 5 rounds, it went into slide lock but not with the slide lock lever. It was actually jammed in the rear position. I bumped it with my hand, and it broke loose, and stripped a round. Didn't like what I was seeing, so unloaded, and manually opened the slide. It was getting in a bind at the rear of the cycle. Thought maybe it was the buffer spacer, so removed it, and made no change. Still binding. </p><p>At home, with the upper opened, the bolt moves in and out easily. When closing the upper with the lower, it starts binding again at the back of the stroke. It appears the Timney trigger may be the culprit. Not depressing enough to allow the bolt to run freely. I'll remove the trigger tomorrow and then cycle the bolt to see if there is any difference. </p><p>There are two Rise Armament triggers coming in the mail tomorrow, with some anti-walk pins so one of them will likely go back in.</p><p>Thought about removing some material from the bottom of the bolt, but decided to hold off until making sure it's the trigger.</p></blockquote><p></p>
[QUOTE="dennishoddy, post: 3246797, member: 5412"] Well, went to the range today and loaded up the mag. Started with two shots in rapid fire mode, then after about 5 rounds, it went into slide lock but not with the slide lock lever. It was actually jammed in the rear position. I bumped it with my hand, and it broke loose, and stripped a round. Didn't like what I was seeing, so unloaded, and manually opened the slide. It was getting in a bind at the rear of the cycle. Thought maybe it was the buffer spacer, so removed it, and made no change. Still binding. At home, with the upper opened, the bolt moves in and out easily. When closing the upper with the lower, it starts binding again at the back of the stroke. It appears the Timney trigger may be the culprit. Not depressing enough to allow the bolt to run freely. I'll remove the trigger tomorrow and then cycle the bolt to see if there is any difference. There are two Rise Armament triggers coming in the mail tomorrow, with some anti-walk pins so one of them will likely go back in. Thought about removing some material from the bottom of the bolt, but decided to hold off until making sure it's the trigger. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
9mm PCC
Search titles only
By:
Top
Bottom