Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
AK-74 Maintenance bore rods
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="trbii" data-source="post: 3744039" data-attributes="member: 2449"><p>I don’t dispute your word on those cleaning rod lengths, it’s just my experience with a couple of Arsenal Inc. AK platform carbines was confounding, confusing. The rods slid into the under barrel storage area were 3-4” too short. Do you also say .22 caliber rods will fit into 5.45MM bore? Just measured the rod that came on my Arsenal SA M-7 7.62 X 39 carbine. Rod is 15 3/4”, barrel including flash suppressor is 17 3/4”. I use one of my 26”-30” one piece rods to stroke that 30 cal bore out. I did buy a AK cleaning kit packaged in a metal tube to stow in the hollow butt models, which I don’t have. The little short section of rod that is included with that kit screws on and barely makes the length needed for the 7.62 caliber.</p></blockquote><p></p>
[QUOTE="trbii, post: 3744039, member: 2449"] I don’t dispute your word on those cleaning rod lengths, it’s just my experience with a couple of Arsenal Inc. AK platform carbines was confounding, confusing. The rods slid into the under barrel storage area were 3-4” too short. Do you also say .22 caliber rods will fit into 5.45MM bore? Just measured the rod that came on my Arsenal SA M-7 7.62 X 39 carbine. Rod is 15 3/4”, barrel including flash suppressor is 17 3/4”. I use one of my 26”-30” one piece rods to stroke that 30 cal bore out. I did buy a AK cleaning kit packaged in a metal tube to stow in the hollow butt models, which I don’t have. The little short section of rod that is included with that kit screws on and barely makes the length needed for the 7.62 caliber. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
AK-74 Maintenance bore rods
Search titles only
By:
Top
Bottom