Got in my Juliet 5X Micro today (a few days early from the USPS, go figure) and it mounts up just fine. Now to take it to the range.
New bipod for the .300 PRC. Much more solid and wider than my V8. My V8 may get replaced.
View attachment 340575
Very nice. I have two of the BRMS models I want to swap from swivel over to quick detach.
Very nice. I have two of the BRMS models I want to swap from swivel over to quick detach.
It may just be that the box sits lower on the sides. Move them around and see if the outside edge still sits lower.Hmm, some of these are not like the others. Makes me wonder about quality control.
View attachment 340702
Ha, two of the bullets are seated way too far into the case.It may just be that the box sits lower on the sides. Move them around and see if the outside edge still sits lower.
Wow. I've had some variances before, but that's the difference between boom and kaboom! If you reload, you can fix it. If not, give em to your enemyHmm, some of these are not like the others. Makes me wonder about quality control.
View attachment 340702
Hmm, some of these are not like the others. Makes me wonder about quality control.
View attachment 340702
It is 100% the rounds. It’s not exactly hard to pull them out of the holder and look at them. Then see the bullet is seated much deeper . It was the first thing I did.I have a box of .223 like that, but only round.
Move shells around. It's not the rounds, it the shell holder.
At least it was in mine.
I went to prime some .357 brass. RCBS hand primer was set up for large primers. Since the move, I couldn't find the stem and small primer cup.
Found a NOS hand primer on eBay, at a good price ($20, shipped). No more changing. Have a LARGE and SMALL hand primer, ready to go at anytime.
When ordering hand primer, found a cross draw holster for my new Cowboy rig.
(Main reason I avoid eBay, I "find" too much)
Enter your email address to join: