Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Anyone know about 9mm Colt AR's in BA? Also M&P15-22 good deal at same place.
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Super Dave" data-source="post: 1721182" data-attributes="member: 8429"><p>Sweet Dave, you're on!</p><p></p><p>What kind of mag block do you use? I only have experienced the one Hahn makes for Spikes. It locks in place with two expanding tensioners. I measure it from the top of the lower receiver each time I take it out. .020" proud of the top surface. Like I said, I'm anal. I really like it because you can adjust the height of the ejector. </p><p></p><p>I am hoping putting a little material on the back side will eliminate the wobble potential in any setup. It will both fill the gap some, and push the magazine to fit more under the thin lip of the bullet guide. </p><p></p><p>Anyway, what kind of receiver do you have also? Are you gonna be in OKC any time soon? If so, holler, and bring it by. I'd like to take a few measurements.</p></blockquote><p></p>
[QUOTE="Super Dave, post: 1721182, member: 8429"] Sweet Dave, you're on! What kind of mag block do you use? I only have experienced the one Hahn makes for Spikes. It locks in place with two expanding tensioners. I measure it from the top of the lower receiver each time I take it out. .020" proud of the top surface. Like I said, I'm anal. I really like it because you can adjust the height of the ejector. I am hoping putting a little material on the back side will eliminate the wobble potential in any setup. It will both fill the gap some, and push the magazine to fit more under the thin lip of the bullet guide. Anyway, what kind of receiver do you have also? Are you gonna be in OKC any time soon? If so, holler, and bring it by. I'd like to take a few measurements. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Anyone know about 9mm Colt AR's in BA? Also M&P15-22 good deal at same place.
Search titles only
By:
Top
Bottom