Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
Anyone On Here Work With Brass Plating?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Backstrap" data-source="post: 3160395" data-attributes="member: 19247"><p>I’m working on a project at my home to replace a couple of brass plates that were installed as combination doorbells/speakers on a couple of exterior doors when the house was built almost 20 years ago. Going to install Ring doorbells in the 4”x6” junction boxes that the old brass plates covered, but I’ll need two new plates with one cutout in the middle of each for the Ring device and screw holes drilled top and bottom for mounting on the boxes. I don’t have the new brass plates but do have the old ones that can be used as a template. I’m in Tulsa but would be willing to travel to OKC or thereabouts to get the job done. PM me if you have access to 3/16” thick brass plating and are interested in tackling this.</p></blockquote><p></p>
[QUOTE="Backstrap, post: 3160395, member: 19247"] I’m working on a project at my home to replace a couple of brass plates that were installed as combination doorbells/speakers on a couple of exterior doors when the house was built almost 20 years ago. Going to install Ring doorbells in the 4”x6” junction boxes that the old brass plates covered, but I’ll need two new plates with one cutout in the middle of each for the Ring device and screw holes drilled top and bottom for mounting on the boxes. I don’t have the new brass plates but do have the old ones that can be used as a template. I’m in Tulsa but would be willing to travel to OKC or thereabouts to get the job done. PM me if you have access to 3/16” thick brass plating and are interested in tackling this. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
Anyone On Here Work With Brass Plating?
Search titles only
By:
Top
Bottom