Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
AR-15 conversion ?'s
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Beercules" data-source="post: 1048529" data-attributes="member: 4713"><p>First off...get one...they are well worth the money. Spikes, CMMG, or Ciener with BDM mags. I currently run a Spikes (and love it) and previously wore out a Ciener. Both of them run (or ran in the case of the Ciener) like sewing machines after they had a 15 minute polish job. I've shot the drop in kits with relative accuracy out of my 1x7 11.5" and 20" rifles at 200 yds.</p><p></p><p>They are dirty and you'll have to clean them and the gun much more than a 5.56-only gun. </p><p></p><p>I have experienced a blocked gas port in my 11.5" SBR running a suppressor and conversion. I was lazy and didn't run 5.56 in the rifle for well over 5000rds of .22. The FSB had to be removed to clear the gas port and the gas tube had to be replaced. Just make sure to run a few rounds of 5.56 after you use the conversion kit and you'll be good to go.</p></blockquote><p></p>
[QUOTE="Beercules, post: 1048529, member: 4713"] First off...get one...they are well worth the money. Spikes, CMMG, or Ciener with BDM mags. I currently run a Spikes (and love it) and previously wore out a Ciener. Both of them run (or ran in the case of the Ciener) like sewing machines after they had a 15 minute polish job. I've shot the drop in kits with relative accuracy out of my 1x7 11.5" and 20" rifles at 200 yds. They are dirty and you'll have to clean them and the gun much more than a 5.56-only gun. I have experienced a blocked gas port in my 11.5" SBR running a suppressor and conversion. I was lazy and didn't run 5.56 in the rifle for well over 5000rds of .22. The FSB had to be removed to clear the gas port and the gas tube had to be replaced. Just make sure to run a few rounds of 5.56 after you use the conversion kit and you'll be good to go. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
AR-15 conversion ?'s
Search titles only
By:
Top
Bottom