Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
AR-15 Measurements
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="pdcrig" data-source="post: 1052387" data-attributes="member: 6358"><p>The acuwedge wouldn't have helped much. The TI lower has a built in nylon tensioning screw that helped some but not enough. I had a couple of leftover .004 inch cylindar end shake bearings and one was almost enough to get it tight. So I know know what I need to do. I'll just order a TI upper and make sure the part I need is right. Thanks guys.</p></blockquote><p></p>
[QUOTE="pdcrig, post: 1052387, member: 6358"] The acuwedge wouldn't have helped much. The TI lower has a built in nylon tensioning screw that helped some but not enough. I had a couple of leftover .004 inch cylindar end shake bearings and one was almost enough to get it tight. So I know know what I need to do. I'll just order a TI upper and make sure the part I need is right. Thanks guys. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
AR-15 Measurements
Search titles only
By:
Top
Bottom