Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Handgun Discussion
Browning Hi Power 9mm barrel
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Buzzdraw" data-source="post: 1753591" data-attributes="member: 385"><p>The factory barrel bore spec's run big; in the .356+ range. They usually won't shoot well unless you shoot bullets chosen to fit the bore of your particular barrel. Additionally the factory barrel is of two part construction. The chamber area is pressed onto the bore section. This does not present a problem in most cases. I have seen them before where separation was occurring at the "crack" where the two join.</p><p></p><p>+1 for a Bar-Sto, if you plan on keeping the HP. Bar-Sto's are of one piece construction and have a .355 bore to shoot all the conventionally available 9mm ammo.</p><p></p><p>As a heads up, the HP's made after about 1995 have cast frames and do not hold up to long use as well as the earlier forged framed units.</p></blockquote><p></p>
[QUOTE="Buzzdraw, post: 1753591, member: 385"] The factory barrel bore spec's run big; in the .356+ range. They usually won't shoot well unless you shoot bullets chosen to fit the bore of your particular barrel. Additionally the factory barrel is of two part construction. The chamber area is pressed onto the bore section. This does not present a problem in most cases. I have seen them before where separation was occurring at the "crack" where the two join. +1 for a Bar-Sto, if you plan on keeping the HP. Bar-Sto's are of one piece construction and have a .355 bore to shoot all the conventionally available 9mm ammo. As a heads up, the HP's made after about 1995 have cast frames and do not hold up to long use as well as the earlier forged framed units. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Handgun Discussion
Browning Hi Power 9mm barrel
Search titles only
By:
Top
Bottom