Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
NFA & Class III Discussion
Can a 16" carbine barrel be cut down and threaded for an NFA project?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="UnSafe" data-source="post: 2580753" data-attributes="member: 100"><p>And if so, how short before the gas system no longer works?</p><p>16" complete uppers are cheap and plentiful. Harder to find dedicated 10.5" or 12" barreled uppers as cheap. As well, don't know if the cut/thread/crown cost would cancel out any savings.</p></blockquote><p></p>
[QUOTE="UnSafe, post: 2580753, member: 100"] And if so, how short before the gas system no longer works? 16" complete uppers are cheap and plentiful. Harder to find dedicated 10.5" or 12" barreled uppers as cheap. As well, don't know if the cut/thread/crown cost would cancel out any savings. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
NFA & Class III Discussion
Can a 16" carbine barrel be cut down and threaded for an NFA project?
Search titles only
By:
Top
Bottom