Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
NFA & Class III Discussion
current engraving requirements
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="RobC" data-source="post: 1068080" data-attributes="member: 687"><p>I have a Form 1 in the papermill right now on which I intentionally left block 4H blank. If it gets approved, as is, I am not going to engrave a thing. If it gets bounced back, I will have the trust name and location engraved when I send it off to have the stock attached. </p><p></p><p>One of my ARs is engraved on the starboard side of the magazine well. It is totally covered up by my redi-mod. I guess that I should get it engraved someplace more visible, but I just don't really care that much.</p><p></p><p></p><p></p><p></p><p>Rob</p></blockquote><p></p>
[QUOTE="RobC, post: 1068080, member: 687"] I have a Form 1 in the papermill right now on which I intentionally left block 4H blank. If it gets approved, as is, I am not going to engrave a thing. If it gets bounced back, I will have the trust name and location engraved when I send it off to have the stock attached. One of my ARs is engraved on the starboard side of the magazine well. It is totally covered up by my redi-mod. I guess that I should get it engraved someplace more visible, but I just don't really care that much. Rob [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
NFA & Class III Discussion
current engraving requirements
Search titles only
By:
Top
Bottom