Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Handgun Discussion
Cylinder Endshake bearings for a K frame Mod 66-1
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="diggler1833" data-source="post: 3603827" data-attributes="member: 48072"><p>I've worked on two older Smiths (29-2 and 629 no dash) with both cylinder and yoke endshake issues. I am not sure about local sources that have this stuff on hand...but a bearing kit from Power Custom (they are just shims a thousandth or two thick) was all that I needed to get my revolvers back just about to new.</p><p></p><p>Best of luck to you.</p></blockquote><p></p>
[QUOTE="diggler1833, post: 3603827, member: 48072"] I've worked on two older Smiths (29-2 and 629 no dash) with both cylinder and yoke endshake issues. I am not sure about local sources that have this stuff on hand...but a bearing kit from Power Custom (they are just shims a thousandth or two thick) was all that I needed to get my revolvers back just about to new. Best of luck to you. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Handgun Discussion
Cylinder Endshake bearings for a K frame Mod 66-1
Search titles only
By:
Top
Bottom