Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
DIY fully carbon fiber knife building. :) Lots of pics!
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="71buickfreak" data-source="post: 1456401" data-attributes="member: 8373"><p>I have two rolls of pre-preg and about a half a roll of laminating material. I guarantee that carbon fiber would be stronger than a high-carbon steel blade of the same length and thickness. Using the laminate I have, two sheets of CF (2"x2"), baked in my oven for 20 mintues at 400 degrees can't be flexed by hand. It will conduct electricity too. With the right top coat, it would look bad ass. I think I might try this out. Interestingly, this would create a knife that is undetectable to metal detectors....... </p><p></p><p>CF is fairly affordable in small quantities, like what you would nee for this kind of project.</p><p></p><p><a href="http://www.assistedknife.com/index.cfm/fa/subcategories.main/parentcat/25000/subcatid/59409" target="_blank">http://www.assistedknife.com/index.cfm/fa/subcategories.main/parentcat/25000/subcatid/59409</a></p></blockquote><p></p>
[QUOTE="71buickfreak, post: 1456401, member: 8373"] I have two rolls of pre-preg and about a half a roll of laminating material. I guarantee that carbon fiber would be stronger than a high-carbon steel blade of the same length and thickness. Using the laminate I have, two sheets of CF (2"x2"), baked in my oven for 20 mintues at 400 degrees can't be flexed by hand. It will conduct electricity too. With the right top coat, it would look bad ass. I think I might try this out. Interestingly, this would create a knife that is undetectable to metal detectors....... CF is fairly affordable in small quantities, like what you would nee for this kind of project. [url]http://www.assistedknife.com/index.cfm/fa/subcategories.main/parentcat/25000/subcatid/59409[/url] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
DIY fully carbon fiber knife building. :) Lots of pics!
Search titles only
By:
Top
Bottom