Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Do you have to size before trimming?
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Rez Exelon" data-source="post: 3785096" data-attributes="member: 5800"><p>My process for what it's worth.</p><p></p><p>1. Decap --- universal Lee decapper</p><p>2. Tumble clean.</p><p>3. Dump in pan, spritz with mix of lanolin+995IPA and hand mix</p><p>4. Size</p><p>5. Check if trimming is needed, trim if needed.</p><p>6 Clean Primer Pocket/Chamfer/Deburr</p><p>7. Uniform flash hole (if new brass) </p><p>8. Prime</p><p>9. Load or store. </p><p></p><p>I do steps 5-7 on a bench lathe which goes really quick with my setup. I like the lanolin/IPA mix because it seems to prevent sticking but is "lighter" than some other types of lube I've used. I don't really have any holding on issues. Not sure how the lathe method would compare to the case prep center method in that regard though.</p></blockquote><p></p>
[QUOTE="Rez Exelon, post: 3785096, member: 5800"] My process for what it's worth. 1. Decap --- universal Lee decapper 2. Tumble clean. 3. Dump in pan, spritz with mix of lanolin+995IPA and hand mix 4. Size 5. Check if trimming is needed, trim if needed. 6 Clean Primer Pocket/Chamfer/Deburr 7. Uniform flash hole (if new brass) 8. Prime 9. Load or store. I do steps 5-7 on a bench lathe which goes really quick with my setup. I like the lanolin/IPA mix because it seems to prevent sticking but is "lighter" than some other types of lube I've used. I don't really have any holding on issues. Not sure how the lathe method would compare to the case prep center method in that regard though. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Do you have to size before trimming?
Search titles only
By:
Top
Bottom