Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Function problem with a .308 build:
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Seadog" data-source="post: 3841244" data-attributes="member: 9018"><p>Thanks for that answer on the #41 drill bit. My lazy butt did a little bit of research and already figured that out. I ordered a few carbide drill bits online. A #41 and a #42</p><p></p><p>I assembled a rifle that I haven’t tested out yet. I figure when the drill bit comes in if it goes in it’s the right size if it doesn’t then it’s undersized. I have a 20” ballistic advantage top of their line stainless steel barrel that is bead blasted a nice dull gray. I finally got a few parts in for it this last week and finished it up. I need to go out and function test it but I figure I would get a drill bit to check the gas port hole size 1st before wasting ammo.</p></blockquote><p></p>
[QUOTE="Seadog, post: 3841244, member: 9018"] Thanks for that answer on the #41 drill bit. My lazy butt did a little bit of research and already figured that out. I ordered a few carbide drill bits online. A #41 and a #42 I assembled a rifle that I haven’t tested out yet. I figure when the drill bit comes in if it goes in it’s the right size if it doesn’t then it’s undersized. I have a 20” ballistic advantage top of their line stainless steel barrel that is bead blasted a nice dull gray. I finally got a few parts in for it this last week and finished it up. I need to go out and function test it but I figure I would get a drill bit to check the gas port hole size 1st before wasting ammo. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Function problem with a .308 build:
Search titles only
By:
Top
Bottom