Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Handgun Discussion
Help with my 1911
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="TJay74" data-source="post: 1266407" data-attributes="member: 5857"><p>Ok went back to the range again today. I picked up some Federal target rounds and brought some more of the Winchester PDX1 rounds. I also brought along the new magazine as well.</p><p></p><p>The new mag ran the target rounds without one issue of any sort. Then I took 5 each of the Winchester PDX1 rounds and put them in each magazine. The old one fired just fine, the new magazine did not hang up until the last round and it was a different failure than the original FTF.</p><p></p><p>This time the round hung up on in the internal ramp in the lower and not on the top of the chamber of the barrell like it was doing before. This just might of have been a fluke, I dont know at this point.</p><p></p><p>So it seems maybe the ramp polish job helped. I am going to switch over to CCI/Speer Gold-dot as that is what I run in the rest of my auto's and the nose of the round is alot more uniformed with no "teeth" like the PDX1 has.</p><p></p><p>I will report back after that range test, I have to order the ammo as no one locally carries it that I know of.</p></blockquote><p></p>
[QUOTE="TJay74, post: 1266407, member: 5857"] Ok went back to the range again today. I picked up some Federal target rounds and brought some more of the Winchester PDX1 rounds. I also brought along the new magazine as well. The new mag ran the target rounds without one issue of any sort. Then I took 5 each of the Winchester PDX1 rounds and put them in each magazine. The old one fired just fine, the new magazine did not hang up until the last round and it was a different failure than the original FTF. This time the round hung up on in the internal ramp in the lower and not on the top of the chamber of the barrell like it was doing before. This just might of have been a fluke, I dont know at this point. So it seems maybe the ramp polish job helped. I am going to switch over to CCI/Speer Gold-dot as that is what I run in the rest of my auto's and the nose of the round is alot more uniformed with no "teeth" like the PDX1 has. I will report back after that range test, I have to order the ammo as no one locally carries it that I know of. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Handgun Discussion
Help with my 1911
Search titles only
By:
Top
Bottom