Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Help with trimming 30 Carbine brass
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="swampratt" data-source="post: 3189123" data-attributes="member: 15054"><p>I have used the Lee quick trim and HATE it. very inconsistent and the chamfer is not VLD and I need VLD.</p><p>The most consistent and easiest trimmer I have used is the Lee case length gauge and shell holder.</p><p>along with the cutter and lock stud.</p><p>I chuck the cutter and case length gauge up in my drill press and have it on lowest speed.</p><p>And hold the case and all in my hand and run it up until it quits cutting then I hand chamfer the case.</p><p></p><p>Trimming takes a couple seconds.</p><p>And you can actually file the pin end down to allow a little more trimming.</p><p>I have a .308 case length gauge that trims my cases to 2.000 and another for 2.010</p></blockquote><p></p>
[QUOTE="swampratt, post: 3189123, member: 15054"] I have used the Lee quick trim and HATE it. very inconsistent and the chamfer is not VLD and I need VLD. The most consistent and easiest trimmer I have used is the Lee case length gauge and shell holder. along with the cutter and lock stud. I chuck the cutter and case length gauge up in my drill press and have it on lowest speed. And hold the case and all in my hand and run it up until it quits cutting then I hand chamfer the case. Trimming takes a couple seconds. And you can actually file the pin end down to allow a little more trimming. I have a .308 case length gauge that trims my cases to 2.000 and another for 2.010 [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Help with trimming 30 Carbine brass
Search titles only
By:
Top
Bottom