Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Hornady LNL AP Tips/Tricks/Tweaks
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="No.343" data-source="post: 2348890" data-attributes="member: 296"><p>I don't have any high tech tips, but here are two things I did. I loaded ten primers then marked the fiber rod. I made another mark when it was empty. I can make a pretty good estimate of how many primers I have left by looking at those two marks. I ground off about half of the lip on one of the die holders with my belt sander. This allows me to use some of my old Lee taper crimp dies. I could use them before, but the locking ring was not engaged. Since the die body is so short I had to screw the die in just past where the locking ring could be engaged.</p></blockquote><p></p>
[QUOTE="No.343, post: 2348890, member: 296"] I don't have any high tech tips, but here are two things I did. I loaded ten primers then marked the fiber rod. I made another mark when it was empty. I can make a pretty good estimate of how many primers I have left by looking at those two marks. I ground off about half of the lip on one of the die holders with my belt sander. This allows me to use some of my old Lee taper crimp dies. I could use them before, but the locking ring was not engaged. Since the die body is so short I had to screw the die in just past where the locking ring could be engaged. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Hornady LNL AP Tips/Tricks/Tweaks
Search titles only
By:
Top
Bottom