Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Handgun Discussion
Long Term Owner Reports on Sig P365/365XL/SAS
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Engineman1960" data-source="post: 3350093" data-attributes="member: 9220"><p>I loosened the Torx screws on the SAS sight (I broke my torx driver, breaking the screws loose) I took a X-Acto blade and jammed it between the sight and the right hand side of the sight cut for the slide. Tightened the Torx screws; shot 72 round (reloads -- 115 grain Montana Gold CMJ with 4.3 grains Winchester 231) today. I had a couple of fliers but the all seemed to hit center mass;I shot at 7, 10 and 15 yards. I have to work a little harder on my sight alignment and trigger press -- I switched back to the standard slide setup; shot 128 rounds (I was happy with the results) before the sun went down. Jury still out on the SAS slide; In low light the sights are hard to pick up, will takes some time to get used to. For me, it is hard to beat the P365 standard X-Ray sights.</p></blockquote><p></p>
[QUOTE="Engineman1960, post: 3350093, member: 9220"] I loosened the Torx screws on the SAS sight (I broke my torx driver, breaking the screws loose) I took a X-Acto blade and jammed it between the sight and the right hand side of the sight cut for the slide. Tightened the Torx screws; shot 72 round (reloads -- 115 grain Montana Gold CMJ with 4.3 grains Winchester 231) today. I had a couple of fliers but the all seemed to hit center mass;I shot at 7, 10 and 15 yards. I have to work a little harder on my sight alignment and trigger press -- I switched back to the standard slide setup; shot 128 rounds (I was happy with the results) before the sun went down. Jury still out on the SAS slide; In low light the sights are hard to pick up, will takes some time to get used to. For me, it is hard to beat the P365 standard X-Ray sights. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Handgun Discussion
Long Term Owner Reports on Sig P365/365XL/SAS
Search titles only
By:
Top
Bottom