Looking for 3/8 dovetail cantilever mount for 1" scope.

[kirk1978]

https://www.amazon.com/MAD3-8PS-Dov...13550&sprefix=3/8+dovetail+to+,aps,145&sr=8-5

 

[Catt57]

Like these...

https://www.pyramydair.com/product/utg-11mm-3-8-dovetail-to-weaver-adapter-2pcs?a=4148

I have a set of those. They haven't worked very well for me. They don't stay put.

 

[O4L]

I have a set of those. They haven't worked very well for me. They don't stay put.

Oh well, I tried.

They worked very well for me on a Browning SA-22.

 

[Catt57]

Like these...

https://www.pyramydair.com/product/utg-11mm-3-8-dovetail-to-weaver-adapter-2pcs?a=4148
They are a lower profile than most adapters.

https://www.amazon.com/MAD3-8PS-Dov...13550&sprefix=3/8+dovetail+to+,aps,145&sr=8-5

I'd rather not go the adapter route if I don't have to. I've not had very good luck with that in the past.

 

[O4L]

I'd rather not go the adapter route if I don't have to. I've not had very good luck with that in the past.

I went with that since I already had the picatinny mount but I understand where you're coming from.

 

[El Pablo]

Yeah, here is my problem. And I can't move the scope any further back without removing the rear sight. And I don't want to do that.

View attachment 431010

But a 3/8 to warne or picatinny adapter. Then you have a ton of options. Use loctite. This is my setup on all my good ,22s. No issues.

 

[El Pablo]

You could also go with taller ring (yuck)

 

[OkieShutr]

Go through UTG/LEAPERS products. They may have what you need.