Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rifle & Shotgun Discussion
Marlin barrel cut down
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Dr. Tad Hussein Winslow" data-source="post: 1218518" data-attributes="member: 7123"><p>I think a good smith can cut the tube mag, cut a few coils off the spring to the right point, and re-attach the old 'lid' with a detent or the lid itself for a spring stop, however it may be set up. It can definitely be done; just a matter of finding a qualified gunsmith to do it - or do it yourself. Then, cut n crown for the barrel, re-blue, and possibly re-attach the front sight (if not an optics-only gun).</p><p></p><p>I think it's a fantastic idea - especially in .35 Rem. The Maurader 336 is the old discontinued 16" in .30-30 - too bad they don't bring this back. Dunno if they ever made the Marauder in .35 Rem. The Winchester Ranger was the 94 in 16" .30-30 - these can be found for sale used much easier than the Marauder. Doubt that any of them were in .35 Rem though. </p><p></p><p>So I say it's a great brush gun plan!</p></blockquote><p></p>
[QUOTE="Dr. Tad Hussein Winslow, post: 1218518, member: 7123"] I think a good smith can cut the tube mag, cut a few coils off the spring to the right point, and re-attach the old 'lid' with a detent or the lid itself for a spring stop, however it may be set up. It can definitely be done; just a matter of finding a qualified gunsmith to do it - or do it yourself. Then, cut n crown for the barrel, re-blue, and possibly re-attach the front sight (if not an optics-only gun). I think it's a fantastic idea - especially in .35 Rem. The Maurader 336 is the old discontinued 16" in .30-30 - too bad they don't bring this back. Dunno if they ever made the Marauder in .35 Rem. The Winchester Ranger was the 94 in 16" .30-30 - these can be found for sale used much easier than the Marauder. Doubt that any of them were in .35 Rem though. So I say it's a great brush gun plan! [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rifle & Shotgun Discussion
Marlin barrel cut down
Search titles only
By:
Top
Bottom