Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Water Cooler
General Discussion
Miller mig welders
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="_CY_" data-source="post: 1553852" data-attributes="member: 7629"><p>got a DEWALT DW872, slow moving carbide tipped blade. really makes short work of cutting metals. </p><p></p><p>look at what I scored today.... still loaded on my trailer</p><p>1. Miller XMT 304</p><p>2. Miller 330 AB/P TIG with high frequency and wet TIG torch setup. 450amp AC/DC</p><p></p><p>hopefully should have the XMT304 up and running soon. the Miller 330 AB/P was working fine when it was taken out of service. </p><p></p><p>luckily I've got 3 phase service at home. one of the few places in Tulsa with residential 3 phase. 3 phase delta with a wild leg (higher voltage on one leg)</p><p></p><p>sure hope I can get the Miller 330 going again. it's going to require wiring in a new 3 phase circuit. probably could get by on 60 amps per leg. sure glad I've already got #4 copper wire and a three phase breaker box for this. </p><p></p><p><strong>[Broken External Image]</strong></p><p></p><p>[ATTACH=full]92174[/ATTACH]</p></blockquote><p></p>
[QUOTE="_CY_, post: 1553852, member: 7629"] got a DEWALT DW872, slow moving carbide tipped blade. really makes short work of cutting metals. look at what I scored today.... still loaded on my trailer 1. Miller XMT 304 2. Miller 330 AB/P TIG with high frequency and wet TIG torch setup. 450amp AC/DC hopefully should have the XMT304 up and running soon. the Miller 330 AB/P was working fine when it was taken out of service. luckily I've got 3 phase service at home. one of the few places in Tulsa with residential 3 phase. 3 phase delta with a wild leg (higher voltage on one leg) sure hope I can get the Miller 330 going again. it's going to require wiring in a new 3 phase circuit. probably could get by on 60 amps per leg. sure glad I've already got #4 copper wire and a three phase breaker box for this. [b][Broken External Image][/b] [attach=full]92174[/attach] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Water Cooler
General Discussion
Miller mig welders
Search titles only
By:
Top
Bottom