Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
need help identifying bullet mold
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ok-22shooter" data-source="post: 3540298" data-attributes="member: 42477"><p>picked up this bullet mold as part of a package deal a while back. no name or caliber identification. mold blocks are aluminum. steel sprue place. cavity looks very good. alignment pin holes are a little loose. I think the pins could be driven out some to go deeper into "virgin" bore in other block. very short slots in back for handles, not the long channels like most molds. width of slot and pins are pretty close to the standard mold.will polish sprue plate. overall quality is not up to modern manufacturers so may be small custom manufacturer. base of bullet measures .431" so 44 caliber. bullet would be about .7" long. any one have any idea on what handles would work? will be casting 40 cal bullets next week and will hold blocks together with clamp if I can not find handles to get idea of weight and actual cast diameter. thanks for any help</p></blockquote><p></p>
[QUOTE="ok-22shooter, post: 3540298, member: 42477"] picked up this bullet mold as part of a package deal a while back. no name or caliber identification. mold blocks are aluminum. steel sprue place. cavity looks very good. alignment pin holes are a little loose. I think the pins could be driven out some to go deeper into "virgin" bore in other block. very short slots in back for handles, not the long channels like most molds. width of slot and pins are pretty close to the standard mold.will polish sprue plate. overall quality is not up to modern manufacturers so may be small custom manufacturer. base of bullet measures .431" so 44 caliber. bullet would be about .7" long. any one have any idea on what handles would work? will be casting 40 cal bullets next week and will hold blocks together with clamp if I can not find handles to get idea of weight and actual cast diameter. thanks for any help [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
need help identifying bullet mold
Search titles only
By:
Top
Bottom