Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
Nosler Brass
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Gadsden" data-source="post: 3768362" data-attributes="member: 49555"><p>The brass case, without a bullet seated in it, fits and ejects fine. It's when I seat a bullet, no matter what total length the cartridge is, that I run into problems. There was one exception it worked <em>fairly</em> well when the bullet was seated well below the recommended minimum OAL. That scares me because I'm afraid that, with powder (at this point I'm experimenting with no powder) the pressure would be much too high.</p></blockquote><p></p>
[QUOTE="Gadsden, post: 3768362, member: 49555"] The brass case, without a bullet seated in it, fits and ejects fine. It's when I seat a bullet, no matter what total length the cartridge is, that I run into problems. There was one exception it worked [I]fairly[/I] well when the bullet was seated well below the recommended minimum OAL. That scares me because I'm afraid that, with powder (at this point I'm experimenting with no powder) the pressure would be much too high. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
Nosler Brass
Search titles only
By:
Top
Bottom