Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Competition, Tactics & Training
Competitions & Upcoming Events
OKC Gun Club Match 6-Mar-10
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ninefan" data-source="post: 1044874" data-attributes="member: 2401"><p>Yeah, the STI is spoiling me. No issues with sudden mag spring death. The 40 cal Glock was never really tolerant of leaving an extended mag fully loaded for long. The 9mm never seemed to care though even with 22-23 rnds stuffed in the mags.</p><p></p><p>I would load them up to 15, then add on another 5 to each right before I shot. Other than that I have had the main locking block pin shear, but that just caused trigger reset issues more than anything IIRC.</p><p></p><p>Extraction/ejection problems could be the extractor, extractor plunger spring/spring loaded bearing (make sure that the little spring loaded bearing is actually there), ejector/trigger housing tip shape or orientation, or possibly slide speed issues (due to loads / different recoil spring). I can't think of anything else off the top of my head that it would likely be.</p></blockquote><p></p>
[QUOTE="ninefan, post: 1044874, member: 2401"] Yeah, the STI is spoiling me. No issues with sudden mag spring death. The 40 cal Glock was never really tolerant of leaving an extended mag fully loaded for long. The 9mm never seemed to care though even with 22-23 rnds stuffed in the mags. I would load them up to 15, then add on another 5 to each right before I shot. Other than that I have had the main locking block pin shear, but that just caused trigger reset issues more than anything IIRC. Extraction/ejection problems could be the extractor, extractor plunger spring/spring loaded bearing (make sure that the little spring loaded bearing is actually there), ejector/trigger housing tip shape or orientation, or possibly slide speed issues (due to loads / different recoil spring). I can't think of anything else off the top of my head that it would likely be. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
Competition, Tactics & Training
Competitions & Upcoming Events
OKC Gun Club Match 6-Mar-10
Search titles only
By:
Top
Bottom