Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
Polymer80 Glock-ish troubleshooting assistance
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="cmeilahn" data-source="post: 3684936" data-attributes="member: 49725"><p>I have a Polymer80 pf940c build with which I need some assistance troubleshooting the slide actions. Everything cycles fine when empty. With a laser trainer or snap cap/trainer/dummy round, the slide doesn't fully close forward with light slide pulls (ex. chamber check). I'm happy to work with a gunsmith, Glock armorer, experienced builder, etc. to figure this out. I have a 26-ish (pf940sc) build that needed some rail work to get functioning smoothly, but this one has been a bit of a challenge. </p><p></p><p>Yes, I've gone through dozens of videos, several Glock guides, including an armorers manual, and polished the internals... some multiple times. </p><p></p><p>We just moved to the area in June. Does anyone have recommendations for someone in the Tulsa area with good knowledge & experience troubleshooting Glocks & Glock-ish builds?</p></blockquote><p></p>
[QUOTE="cmeilahn, post: 3684936, member: 49725"] I have a Polymer80 pf940c build with which I need some assistance troubleshooting the slide actions. Everything cycles fine when empty. With a laser trainer or snap cap/trainer/dummy round, the slide doesn't fully close forward with light slide pulls (ex. chamber check). I'm happy to work with a gunsmith, Glock armorer, experienced builder, etc. to figure this out. I have a 26-ish (pf940sc) build that needed some rail work to get functioning smoothly, but this one has been a bit of a challenge. Yes, I've gone through dozens of videos, several Glock guides, including an armorers manual, and polished the internals... some multiple times. We just moved to the area in June. Does anyone have recommendations for someone in the Tulsa area with good knowledge & experience troubleshooting Glocks & Glock-ish builds? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
Polymer80 Glock-ish troubleshooting assistance
Search titles only
By:
Top
Bottom