Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rimfire Weapons
Project preview - "Squirrelberg"
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Catt57" data-source="post: 2758982" data-attributes="member: 34578"><p>So since the Marlin and Mossberg receivers are almost spot on identical, the plan right now is to open up the Marlin stock to allow a block to be glued in just below where the receiver will sit and then inlet for the Mossberg trigger group. I will leave the bottom front and sides and only cut out for the trigger group there. If all goes well the only place that will need to be filled is on the bottom at the rear of the action. I should be able to use the material I cut out of the bottom to make a fill piece for that area. Then after a full refinish it should look like it was never even modified.</p><p></p><p>That's the idea anyway....</p></blockquote><p></p>
[QUOTE="Catt57, post: 2758982, member: 34578"] So since the Marlin and Mossberg receivers are almost spot on identical, the plan right now is to open up the Marlin stock to allow a block to be glued in just below where the receiver will sit and then inlet for the Mossberg trigger group. I will leave the bottom front and sides and only cut out for the trigger group there. If all goes well the only place that will need to be filled is on the bottom at the rear of the action. I should be able to use the material I cut out of the bottom to make a fill piece for that area. Then after a full refinish it should look like it was never even modified. That's the idea anyway.... [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rimfire Weapons
Project preview - "Squirrelberg"
Search titles only
By:
Top
Bottom