Reloading bench.

[Jedabug92]

What do yall use?
Build one or buy one. I have a press and need a bench and ideas.

 

[Jedabug92]

And forgot to mention something small ish. 56 wide max. I'm in an apartment/dorm size room and no garage.

 

[dennishoddy]

Harbor Freight sells a wood work bench that a lot of reloaders like. It's really close to your specs.

 

[magna19]

I built mine with what look like mailbox post from Lowes. They had slots already cut in the top. I cut them to the length I needed and had a center leaf from a dining room table I no longer had. Working out pretty good so far.

 

[Jedabug92]

I built mine with what look like mailbox post from Lowes. They had slots already cut in the top. I cut them to the length I needed and had a center leaf from a dining room table I no longer had. Working out pretty good so far.

Looks like we both have the chucker
How bad does it torque the table

 

[magna19]

Been loading 300 RUM and has held up great. There are 4 spots reinforced underneath that was already there. That is wear the press is mounted.

 

[Jedabug92]

Ok awesome. I don't want my .308 to break the bench haha.

 

[Jedabug92]

And how did you mount the press. Any specific hardware?

 

[magna19]

Two bolts the correct length should work great. Fairly large washers on bottom for sure. Mount press as far back toward the front edge of the top.

 

[Jedabug92]

Ok awesome. I have to find the right size nuts and bolts.