Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Rimfire Weapons
Ruger 10/22 Question
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="stroker-c10" data-source="post: 1103855" data-attributes="member: 6929"><p>Thanks for the info, never saw the reply. I installed the shims properly and I did go ahead and use the factory spring between the disconnecter and sear. I did however replace the spring with the supplied volquartsen spring. I have shot plenty of rounds through it (unsure on round count), and it never seemed to have an issue with the factory hammer. I have heard some say polish the hammer but am unsure as to how much this would help.</p></blockquote><p></p>
[QUOTE="stroker-c10, post: 1103855, member: 6929"] Thanks for the info, never saw the reply. I installed the shims properly and I did go ahead and use the factory spring between the disconnecter and sear. I did however replace the spring with the supplied volquartsen spring. I have shot plenty of rounds through it (unsure on round count), and it never seemed to have an issue with the factory hammer. I have heard some say polish the hammer but am unsure as to how much this would help. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Rimfire Weapons
Ruger 10/22 Question
Search titles only
By:
Top
Bottom