BTW, you did good.The factory DA pull was 24 pounds??????
Just fell into the site!! What's old is new again!!!
Looking at David's last price list, price was $1,200 for a full custom Ruger Super Redhawk or Super Blackhawk with a 6 week turnaround time, and included the following work:
Trigger job - single action pull 2 1/2 pounds on both action types and double action pull set at customers desired pull weight
Action truing
Bore and cylinder lapping
Cylinder chambers cut to the same exact dimensions
Barrel to cylinder gap set to .003
Forcing cone cut, honed and polished to "Taylor" dimensions
Barrel cut, threaded and crowned
Custom muzzle brake installation with an oversized muzzle brake or muzzle brake turned down to match the barrel diameter with no visible seam line showing between the barrel and brake
Factory grip replaced with a Hogue Finger Groove grip and set up for sling carry
Sling swivel stud installed in muzzle brake
Drill and tap for custom scope base
Customers choice of scope rings
Bushnell Trophy 2X-6X-32mm
Scope mounted and sighted with your choice of loads and distance
1" nylon sling installed
I'm sure there was a lot of other work done on these guns, but this is just a short list of work t
Looking at David's last price list, price was $1,200 for a full custom Ruger Super Redhawk or Super Blackhawk with a 6 week turnaround time, and included the following work:
Trigger job - single action pull 2 1/2 pounds on both action types and double action pull set at customers desired pull weight
Action truing
Bore and cylinder lapping
Cylinder chambers cut to the same exact dimensions
Barrel to cylinder gap set to .003
Forcing cone cut, honed and polished to "Taylor" dimensions
Barrel cut, threaded and crowned
Custom muzzle brake installation with an oversized muzzle brake or muzzle brake turned down to match the barrel diameter with no visible seam line showing between the barrel and brake
Factory grip replaced with a Hogue Finger Groove grip and set up for sling carry
Sling swivel stud installed in muzzle brake
Drill and tap for custom scope base
Customers choice of scope rings
Bushnell Trophy 2X-6X-32mm
Scope mounted and sighted with your choice of loads and distance
1" nylon sling installed
I'm sure there was a lot of other work done on these guns, but this is just a short list of work that was done to make these guns shoot to their best potential
Dean
Enter your email address to join: