Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Handgun Discussion
S&W 340PD Back to The Factory - Again!
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="coolhandluke" data-source="post: 3250181" data-attributes="member: 13284"><p>If the cylinder is not carrying up properly, it likely due to either the ratchets on the extractor not being cut properly or the hand. I'm assuming that the extractor may have been replaced rather than swapping the old one over from the previous cylinder. </p><p></p><p>Did you happen to notice if the cylinder was not carrying up on a specific chamber each time or was it occurring at random?</p></blockquote><p></p>
[QUOTE="coolhandluke, post: 3250181, member: 13284"] If the cylinder is not carrying up properly, it likely due to either the ratchets on the extractor not being cut properly or the hand. I'm assuming that the extractor may have been replaced rather than swapping the old one over from the previous cylinder. Did you happen to notice if the cylinder was not carrying up on a specific chamber each time or was it occurring at random? [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Handgun Discussion
S&W 340PD Back to The Factory - Again!
Search titles only
By:
Top
Bottom