Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
S&W Revolver Detailed Disassembly, Deep Clean and Reassembly
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="_CY_" data-source="post: 1265863" data-attributes="member: 7629"><p>knock off all sharp edges from new cylinder stop. since stop will be dragging on cylinder walls. Arkansas white rock for a fine finish</p><p></p><p>[ATTACH=full]78718[/ATTACH]</p><p></p><p>new cylinder stop is checked for fit ... much better</p><p></p><p>[ATTACH=full]78719[/ATTACH]</p><p></p><p>reassembly is reverse of taking apart...</p><p></p><p>[ATTACH=full]78720[/ATTACH]</p><p></p><p>spring is tricky to get back in without spring flying. screw driver blade needs to be thin enough to fit inside groove, pushing spring over pin</p><p></p><p>[ATTACH=full]78721[/ATTACH]</p><p></p><p>[ATTACH=full]78722[/ATTACH]</p><p></p><p>reassemble cylinder pin with blue locktite, allows later disassembly. </p><p>if pin comes loose, revolver could jam </p><p></p><p>[ATTACH=full]78723[/ATTACH]</p><p></p><p>[ATTACH=full]78724[/ATTACH]</p></blockquote><p></p>
[QUOTE="_CY_, post: 1265863, member: 7629"] knock off all sharp edges from new cylinder stop. since stop will be dragging on cylinder walls. Arkansas white rock for a fine finish [attach=full]78718[/attach] new cylinder stop is checked for fit ... much better [attach=full]78719[/attach] reassembly is reverse of taking apart... [attach=full]78720[/attach] spring is tricky to get back in without spring flying. screw driver blade needs to be thin enough to fit inside groove, pushing spring over pin [attach=full]78721[/attach] [attach=full]78722[/attach] reassemble cylinder pin with blue locktite, allows later disassembly. if pin comes loose, revolver could jam [attach=full]78723[/attach] [attach=full]78724[/attach] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
S&W Revolver Detailed Disassembly, Deep Clean and Reassembly
Search titles only
By:
Top
Bottom