Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Ammo & Reloading
seating depths
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="rockchalk06" data-source="post: 3947324" data-attributes="member: 40794"><p>I used this video when I did load development on my 6.5 using VLD's. I found a charge at 40.9 grains of H4350 that made decent SD's and used it. Started at .030" from jam and worked back. I had to start at .030" to fit in my mag. I ended up grooving out my feed ramp (HMR Pro's have this, HMR's do not) to get them to feed reliability. Found a pretty wide node and was stoked.</p></blockquote><p></p>
[QUOTE="rockchalk06, post: 3947324, member: 40794"] I used this video when I did load development on my 6.5 using VLD's. I found a charge at 40.9 grains of H4350 that made decent SD's and used it. Started at .030" from jam and worked back. I had to start at .030" to fit in my mag. I ended up grooving out my feed ramp (HMR Pro's have this, HMR's do not) to get them to feed reliability. Found a pretty wide node and was stoked. [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Ammo & Reloading
seating depths
Search titles only
By:
Top
Bottom