Unwanted engraving on Glock slide

[Aries]

Then you'll have to be really careful you don't absentmindedly call it by another name...

This sounds like something of which you may have personal experience?

 

[bigfug]

Cheaper to buy a new slide.

That's a job for an engraver and they don't come cheap. Rout out the affected areas. Install a decorative plate into the recess. Engrave something else.

I had my initials engraved on a handgun and later regretted it. Nearly impossible to fix except for the above remedy. Sold it.

It'd be cheaper for you to just change your name to Loretta.

Slides can be had cheap on Brownell's, but the flats can be sanded down depending on depth, and much cheaper than the slide work, actually never heard of the method you mention. Slide lightening and cutouts if he wants a race gun, or just mill that area out, leaving it as is (after refinishing of course) if you want it to look like a zev race gun, or polymer80 like gun

 

[Schlafftablett]

You can sand / surface grind the engraving out then have the slide re-done in DLC. Total cost would be about $175-200.

 

[KOPBET]

Sweet Loretta Martin thought she was a woman but she was another gun.

 

[Neanderthal]

Just give it to me, then you won't have to worry about it.

 

[Gunbuffer]

Obliterate it? A hammer and steel punch

 

[conditionzero]

Lol, at least give us the back story here.

 

[AKguy1985]

Lol, at least give us the back story here.

desire to know more intensifies.



I knew a gal named Loretta. She was like a cat, afraid of water.

 

[xseler]

Have someone scribe "Lynn" below the "Loretta" --- then, sell it on Armslist.........

 

[ssgrock3]

If y’all are out in public, your wife could ask “hey, did you invite Loretta?” Instead of “did you bring your GUN?!?”

helll of an idea. On the other hand, my moms name was Loretta, I will buy it from you