Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Classifieds
Media
New media
New comments
Search media
Log in
Register
What's New?
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Navigation
Install the app
Install
More Options
Advertise with us
Contact Us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
The Range
Gunsmithing & Repairs
Want to finish 80% lowers...
Search titles only
By:
Reply to Thread
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="NightShade" data-source="post: 2940869" data-attributes="member: 29706"><p>You could use someone else's jig but if you don't own the tool it's hard to do another one. However searching around can find a jig for much less than 200 to complete a lower.... <a href="https://www.andersonrifles.com/product/andersons-80-jig/" target="_blank">https://www.andersonrifles.com/product/andersons-80-jig/</a> There are tons of different designs out there and some are higher than others but with that cheap of an option IMHO it's not worth wasting time to search for a used one.</p><p></p><p>As far as using a CNC that someone else owns I remember a thread at some point on the forums of someone in OKC doing something like a build it yourself with their machine. They basically stated that YOU personally had to press the button to start it... Anyway that was a while back and the thread went dead so if you get a little google fu going you might find it and see what is happening. In fact even with a couple glasses of wine I found it... <a href="https://www.okshooters.com/threads/interest-in-finishing-your-own-ar-lower-receiver.165746/" target="_blank">https://www.okshooters.com/threads/interest-in-finishing-your-own-ar-lower-receiver.165746/</a></p></blockquote><p></p>
[QUOTE="NightShade, post: 2940869, member: 29706"] You could use someone else's jig but if you don't own the tool it's hard to do another one. However searching around can find a jig for much less than 200 to complete a lower.... [URL]https://www.andersonrifles.com/product/andersons-80-jig/[/URL] There are tons of different designs out there and some are higher than others but with that cheap of an option IMHO it's not worth wasting time to search for a used one. As far as using a CNC that someone else owns I remember a thread at some point on the forums of someone in OKC doing something like a build it yourself with their machine. They basically stated that YOU personally had to press the button to start it... Anyway that was a while back and the thread went dead so if you get a little google fu going you might find it and see what is happening. In fact even with a couple glasses of wine I found it... [URL]https://www.okshooters.com/threads/interest-in-finishing-your-own-ar-lower-receiver.165746/[/URL] [/QUOTE]
Insert Quotes…
Verification
Post Reply
Forums
The Range
Gunsmithing & Repairs
Want to finish 80% lowers...
Search titles only
By:
Top
Bottom