What did you do in the reloading room today?

[rockchalk06]

Didn't see one of these posts here, so I wanted to start one. Maybe petition the mods for a sticky?

Anyway, today I decapped, reamed/ uniformed primer pockets and debured flash holes on two different lots of 7.62 brass.

My fingers are shot!

 

[swampratt]

I put some of my rifles away and contemplated what rifle would get the New Redfield 6-24x50 scope.
I figured the 30-06 with 110 gr bullets.
I need to get out more brass and get to annealing it and sizing it.

 

[Perplexed]

Haven’t reloaded in several years. Don’t miss it, actually.

 

[retrieverman]

I loaded up and tested some 308 ammo with 180 gr SST’s and 3031 powder in Lapua brass, and it appears to be a good combo.

It was tested in my combo gun.

 

[PanhandleGlocker]

Haven’t loaded in almost a month. I need to make some time to. Hopefully loading for a new caliber soon.

 

[rockchalk06]

Late delivery dropped off an RCBS collet for .264. went ahead and pulled some loades that turned out to be over pressure when I was doing some load development on my 6.5 a few years ago.

 

[dlbleak]

Nothing that I should have…

 

[kwaynem]

Loaded 5 Barnes ttsx 150 grain a few days ago for the 300wsm and resized and cleaned some more nickel plated brass that I got from a fellow OSA member going to test the 5 hopefully this weekend

 

[Rustygun]

today in my reloading corner I ran a batch of nickel plated brass cases through the media tumbler so tomorrow I can load 300-400 rounds of 9mm on my old 650. I have plenty of primers & powder and have 2000 115 grain projectiles from Rocky Mountain reloading (RMR).

 

[Cat City Slim]

I looked at a big box of brass that needs to be sorted, and left the loading room.